Publicidad
Idiomas disponibles
Idiomas disponibles
7. Allow the unit to cool, then recharge before storing away.
8. Store the compressor hose, Sure Fit
in the storage bracket.
120 Volt AC Power Outlets
RATED VERSUS ACTUAL CURRENT DRAW OF EQUIPMENT
Most electrical tools, appliances, electronic devices and audio/visual
equipment have labels that indicate the power consumption in amps or
watts. Be sure that the power consumption of the item to be operated
is below 500 watts. If the power consumption is rated in amps AC,
simply multiply by the AC volts (120) to determine the wattage.
Resistive loads are the easiest for this unit to run; however, it will not
run larger resistive loads (such as electric stoves and heaters), which
require far more wattage than the unit can deliver on a continuous
basis. Inductive loads (such as TVs and stereos) require more current
to operate than do resistive loads of the same wattage rating.
POWER INVERTER OUTPUT WAVEFORM
The AC output waveform of this unit is known as a modified sine wave.
It is a stepped waveform that has characteristics similar to the sine wave
shape of utility power. This type of waveform is suitable for most AC
loads, including linear and switching power supplies used in electronic
equipment, transformers, and small motors.
PROTECTIVE FEATURES
The unit monitors the following conditions:
Low internal battery voltage: The unit will automatically shut down
when the battery voltage drops too low, as this can harm the battery.
High internal battery voltage: The unit will automatically shut down
when the battery voltage is too high, as this can harm the unit.
Thermal shutdown protection: The unit will automatically shut down
when the unit becomes overheated.
Nozzle and nozzle adapter
®
20
Overload/short circuit protection: The unit will automatically shut
down when an overload or short circuit occurs.
Important Notes Concerning the AC Power Outlets
The two AC Power Outlets provide a combined total power draw of
500W.
When the AC Power Outlets are in use, the unit will monitor for the
following fault conditions: thermal fault, low and high battery voltage
fault, overload and short circuit (refer to the "Protective Features"
section).
1. If a low internal battery voltage fault condition exists, the AC Power
Outlets will shut down automatically and the Backlit LCD Screen
will display the following until the fault is corrected:
The Digital Display will show the Battery Voltage Indicator, the
EMPTY Battery Status Icon and Fault Icon on the LCD Screen will
flash.
2. If a high internal battery voltage fault condition exists, the AC Power
Outlets will shut down automatically and the Backlit LCD Screen
will display the following until the fault is corrected:
Publicidad
