BH PROACTION G-635 Manual Del Usuario página 13

- Your monitor picks up signals in a radius of
approximately 75 centimetres. If you are carrying
out exercises too near to another person that is
wearing a pulsometre, your screen can pick up
their signal. To avoid maintain the appropriate
distance.
- Television set, computers, cellular telephones, lines
of high tension and electric motors can produce
Interference.
If you observe an erratic reading move away from
the interference source. Your pulsometre will then
return to work correctly.
It is important to place the chest band correctly to
obtain a correct measure.
CARE AND MAINTENANCE OF THE
TRANSMITTER
- To maintain proper level of operation, the
transmitter has to be cleaned regularly after use
with a mild soap and water solution. If you,
however, want to disinfect your transmitter after
use, a chlorine solution similar to that approved
for pool swimming may be used. Please avoid
untested disinfecting compounds, they may cause
permanent damages to the transmitter. After
disinfecting, transmitter should be cleaned by
water or soap solution to avoid allergic reactions
on skin.
- After using, clean and dry your unit carefully. A
weak signal can be due to dirt.
- Do not expose your band to excessive heat or cold.
- Do not leave your unit exposed to direct sunlight or
in your car
- Keep your unit in a well ventilated place.
Note. Never use abrasives and other chemicals as
they may cause permanent damages to the
electrodes decreasing conductivity or durability.
Storing of transmitter. It is highly recommended to
store transmitter in cool and dry place to maximise
the battery life. Before storage all moisture should
be wiped off.
FREQUENTLY ASKED QUESTIONS
AND ANSWERS
Question 1: Heart rate readings take a long time
to appear.
ELECTRONICO G-635
Answer 1:
If the heart rate readings start appearing after you
start perspiring, this is an indication that the
transmitter electrodes weren't initially wetted
properly prior to commencing the exercise.
Question 2: If there is no heart rate reading, please
check the following things:
Answer 2:
a) The transmitter should be placed on the rib cage
just below the breasts with the word "Polar"
facing out, reading right side up.
b) With the transmitter in position and reasonably
tight around the chest of the user, pull the
transmitter away from the body and wet the
electrodes with water, saliva, contact solution
or other saline solution.
c) If the readings still fail to appear, please have
someone else try the transmitter on and see if
that person can get it to work.
d) The following medical conditions may create
problems:
• Premature ventricular contractions, tachycardia
bursts, and arrythmias can result in strange or
no heart rate readings.
• If the customer has an implanted medical device
such as a pacemaker, you must consult your
physician prior to using the Polar Transmitter.
e) The ECG signal perceived by transmitter is too
weak for successful measurement. Heart
diseases, heart surgeries or natural characteristics
of a heart may result in weak ECG signals. In
many cases, where a weak ECG signal is the
reason for problems, the reliable operation can
be obtained by moving transmitter a little bit to
the left or right. Remember to rewet electrodes.
f) Electromagnetic
transmission can be affected by high power
transmission lines or other such devices that
generate powerful magnetic fields located in
the area of equipment usage. If someone of
your associates has a Polar heart rate monitor,
if possible, borrow it for a while to check that
unit works properly in the area of exercise
equipment. If it does not and it works outside
or another area of the house, the location is
very difficult for wireless heart rate
measurement and the equipment should be
moved to another location.
g) Receiver has broken down for some reason.
14
14
interference.
29/9/04, 09:07
Polar