Introduction for buttons on remote controller
Note:
For preventing cold wind, after starting up heating mode, indoor fan will blow fan
afterdelaying 1-5min. (Details time is decided by indoor ambient temperature)
Temperature setting range on remote controller: 16℃ -30℃ . Fan speed setting
range: auto, low speed, medium speed and high speed.
3
"+" or "-" button
● After each pressing of "+" or "-" button, it can increase or decrease set temper-
ature 1℃ . Hold "+" or "-" button, 2s later, set temperature on remote controller
will change quickly. After reaching to your required time, loosen the button.
Temperature indicator on the unit will also change accordingly. (Temperature
can't be adjusted under auto mode)
● Under TIMER ON, TIMER OFF or Clock setting, you can press "+"or "-" button to
adjust time. (Refer to TIMER button for details)
4
FAN button
Pressing this button can set fan speed circularly as: auto (AUTO), low(
medium(
), high(
Note:
● Under AUTO Speed,IDU fan motor will adjust the fan speed (high, medium or
low speed) according to ambient temperature.
● Fan speed under dry mode is low speed.
5
button
(Not applicable for this unit)
6
(Not applicable for this unit)
button
7
HEALTH SAVE button
HEALTH FUNCTION:
After pressing HEALTH button, remote controller will switch circularly as below:
"HEALTH"→"AIR"→"AIR HEA
● When selecting "HEALTH" by remote controller, HEALTH function will be started up.
● When selecting "AIR" by remote controller, AIR function will be started up. (Not
applicable for this unit)
● When selecting "AIT HEALTH", AIR and HEALTH function will be started up.
● When there's no display on remote controller, AIR and HEALTH function will be
turned off.
).
Auto
LTH"→"no display"
10
),