SOMFY SONESSE2 40 ZIGBEE Manual De Instrucciones página 3

SONESSE2 40 ZIGBEE
1.PRIOR INFORMATION
1.1.Field of application
The Sonesse 40 drives are designed to motorise all types of:
▪ Interior vertical blinds which front rail moves solely by gravity with a mass less than 15 kg.
▪ Tiltable venetian blinds which bottom lath can be lifted at least by 4 cm when an upward force of 150 N is applied to
the bottom lath positioned at 16 cm from the fully extended position.
1.2.Liability
Before installing and using the drive, please read these instructions carefully.
In addition to the instructions provided in this guide, please also comply with the instructions provided in the attached Safety
instructions document.
The drive must be installed by a home motorisation and automation professional, in accordance with Somfy's
instructions and the applicable regulations in the country of installation. For US, the installation shall be done
according to National Electrical Code (NEC) and local codes and shall be always followed.
Any operation of the drive outside the field of application described above is prohibited. Such use, and any failure to comply
with the instructions given in this guide and in the attached Safety instructions document, absolves Somfy of any liability and
invalidates the warranty.
After installing the drive, the installer must inform his customers of the operating and maintenance conditions for the drive
and must provide them with the operating and maintenance instructions, and the attached Safety instructions document.
Any After-Sales Service operation on the drive must be performed by a home motorisation and automation professional.
No user serviceable parts.
Never begin installing without first checking the compatibility of this product with the associated equipment and
accessories. If in doubt when installing this product and/or to obtain additional information, contact a Somfy representative
or visit the website www.somfy.com.
2.INSTALLATION
WARNING
• These instructions are mandatory for the home motorisation and automation professional installing the drive.
• Comply with current standards and legislation in the country of installation.
CAUTION
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.
• To insure optimized silent operation, the gaps between the drive, the accessories, the tube and the tube end piece
must be minimized.
2.1.Assembly
2.1.1.Replace the head cover with a different color (Optional)
1] Remove the screw.
2] Replace the cover with a new cover.
3] Screw the cover at 0,4 N·m.
NOTICE
Head has interchangeable covers to fit with the fabric.
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
EN
3