SOMFY SONESSE2 40 ZIGBEE Manual De Instrucciones página 9

SONESSE2 40 ZIGBEE
1] Press and hold the Up button to move the motorised product to the desired
up position. If necessary, adjust the up position using the Up or Down
buttons.
2] Press the my and Down buttons simultaneously until the motorised product
briefly moves up and down.
ð The upper end limit is memorised.
3] Press and hold the Down button to move the motorised product to the
desired lower position. If necessary, adjust the lower position using the Up or
Down buttons.
4] Press the my and Up buttons simultaneously until the motorised product
briefly moves up and down.
ð The lower end limit is memorised.
▪ To confirm and exit the setting and pair the control point: briefly press the
PROG button of the control point:
◦ → The motorised product briefly moves up and down: the drive is now set
and can be controlled using the control point.
▪ To confirm and exit the setting without pairing the control point: press and
hold the Up and Down buttons on the control point simultaneously, until the
feedback LED on the control point stops flashing.
◦ → The drive is now set and no control point is paired. (To pair the first control
point with an already set drive, refer to the following section).
2.5.5.Pairing the first control point to an already set drive
CAUTION
This procedure cannot be performed on multiple drives at the same time.
NOTICE
Keep the control point close to the drive during the whole procedure.
1] Press and hold the PROG button on the drive until the motorised product
moves up and down briefly and its LED blinks orange: the drive is in
programming mode during 3 min.
2] Briefly press the PROG button on the control point: the motorised product
moves up and down briefly.
g The drive can now be controlled using the control point.
2.5.6.Creating a network with TaHoma ready: add control points and drives in
the installation
▪ To add a new single-channel or multichannel control point to the drive or to delete one of its paired control points:
refer to the control point instruction guide.
▪ To pair additional drives: follow the same procedure of commissioning with a new control point for each drive and
refer to the control point instruction guide to have them share the same network.
2.5.7.Modifying the direction of rotation with a control point
CAUTION
• This procedure cannot be performed on multiple drives at the same time.
• The drive must be set and paired to the control point.
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
1] 2]
3] 4]
1]
2]
EN
9