Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2.5.2.Scanning mode
If several drives are in programming mode, it is possible to be in setting mode with an
undesired drive.
1] Make sure the drive to be paired is still in programming mode. Otherwise,
restart from the beginning of commissioning steps.
2] If the drive to be paired is still in programming mode, bring the control point
close to the drive then briefly press the Up and Down buttons on the
control point simultaneously to exit the setting mode with the previous drive
and scan another close Zigbee drive.
g The motorised product of the new found drive moves up and down
briefly, the drive is in setting mode.
2.5.3.Checking the direction of rotation
Press the Up button on the control point:
a] If the motorised product rises, the direction of rotation is correct: move onto
section Setting the end limits.
b] If the motorised product lowers, the direction of rotation is incorrect: move onto
the next step.
b1] Press the my button on the control point until the motorised product moves up
and down: The direction of rotation has been modified.
b2] Press the Up button on the control point to check the direction of rotation.
2.5.4.Setting the end limits and pairing the control point
NOTICE
The end limits can be set in any order.
8
A
A
b1]
©
Copyright
2023 SOMFY ACTIVITES SA. All rights reserved.
SONESSE2 40 ZIGBEE
A
B
C
...
B
B
C
]
a
]
b
b2]
Publicidad
