WIKA PEW-1000 Manual De Instrucciones página 14

4. Commissioning and operation
Installation of the receiving gateway
Position the gateway in such a way that the transmission power is optimally utilised. For this, the following recommendations
should be observed:
Depending on the application, a gateway for indoor or outdoor use should be selected.
■
EN
The radiation characteristics of the antenna should be taken into account when positioning the gateway.
■
If the sensors are located on one level, vertical mounting of the LoRaWAN
■
The location should ideally be in the middle of the area to be covered.
If the sensors are located on several levels, the gateway should be placed in the middle of the building and the gateway
■
antenna should be aligned horizontally.
Another option is to place the gateway outside the building and align the antenna vertically. In this way, a sufficient radio
■
connection can be established from the outside to several floors.
In outdoor areas, ensure that the gateway is mounted at a sufficient height and not covered by anything in the immediate
■
vicinity. The higher the gateway is positioned, the further the LoRaWAN
14
antenna on the gateway is recommended.
®
connection reaches.
®
WIKA operating instructions pressure sensor, model PEW-1000