Descargar Imprimir esta página

Ricoh SP C360DNw Manual Del Usuario página 19

Ocultar thumbs Ver también para SP C360DNw:

Publicidad

Idiomas disponibles

Idiomas disponibles

Data transmission is always initiated by software, which is the passed down
through the MAC, through the digital and analog baseband, and finally to the
RF chip. Several special packets are initiated by the MAC. These are the only
ways the digital baseband portion will turn on the RF transmitter, which it
then turns off at the end of the packet. Therefore, the transmitter will be on
only while one of the aforementioned packets is being transmitted. In other
words, this device automatically discontinues transmission in case of either
absence of information to transmit or operational failure.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment should be installed and operated keeping the ra-
diator at least 20 cm or more away from person's body (excluding extremities:
hands, wrists, feet and ankles).
Declaration of Conformity
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Responsible party: Ricoh USA, Inc.
Address: 70 Valley Stream Parkway Malvern, Pennsylvania 19355
Telephone number: 610-296-8000
Product Name: Printer
Model Number: SP C360DNw
Notes to Users in the State of California (Notes to Users in USA)
Perchlorate Material - special handling may apply. See: www.dtsc.ca.gov/haz-
ardouswaste/perchlorate
Notes to Canadian Users of Wireless Devices
This device complies with Industry Canada's licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
5150-5250 MHz band is restricted to indoor operation only.
High-power radars are allocated as primary users (i.e. priority users) of the
bands 5250-5350 MHz and 5650-5850 MHz and these radars could cause inter-
ference and/or damage to LE-LAN devices.
15

Publicidad

loading