STAMOS MAGITEX 160 Manual De Instrucciones página 32

An example of a welding torch for the TIG lift method with a gas control valve in the torch.
CAUTION! The TIG torch is not a standard accessory of the kit.
10. Disposal of the packaging
Please keep all packaging material (cardboard, plastic strips and polystyrene foam) to ensure that the
unit is protected during shipment, should it become necessary to send it to a service center!
11. Transport and storage
When transporting the unit, protect it from shocks and tipping over, and do not place it "upside
down". Store the unit in a well-ventilated room where dry air is present and corrosive gases are not
present.
12. Cleaning and maintenance
a) Pull the mains plug before each cleaning and when the unit is not in use and cool the unit
completely.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) Do not spray the unit with a stream of water or immerse it in water.
d) Make sure that no water enters through the ventilation openings in the casing.
e) Clean the ventilation openings with a brush and compressed air.
f) After each cleaning, all the parts should be dried well before the unit is used again.
g) Store the unit in a dry and cool place protected from moisture and direct sunlight.
h) Remove dust regularly with dry and clean compressed air.
i) The machine must be protected from water and moisture.
j) The machine must not be placed on a heated surface.
k) Store the machine in a dry and clean room.
EN