STAMOS MAGITEX 160 Manual De Instrucciones página 23

p) Damaged parts of the device must be repaired or replaced. Use safety belts when working at
heights.
q) All equipment and safety items should be stored in one place.
r) Keep the tip of the handle away from the body when the trigger is activated.
s) Attach the ground cable to the workpiece or as close to it as possible (e.g. to the workbench).
t) The work clamp must be insulated if not connected to the workpiece, to avoid contact with
metal.
u) The product is designed for indoor use. However, if it has been exposed to dampness or rain,
a check must be made to ensure that water droplets do not get inside, which could result in
an accident.
v) Do not allow the unit to get wet.
Caution! The machine may still be live when the power cord is disconnected.
a) After turning off the unit and disconnecting the voltage cable, check the voltage on the input
capacitor and make sure that the voltage value is zero, otherwise do not touch the unit
components.
ATTENTION Although the appliance has been designed to be safe, with adequate safeguards,
and despite the use of additional safety features for the user, there is still a slight risk of accident or
injury when handling the appliance. It is advisable to exercise caution and common sense when using
it.
4.6. Gases and fumes
Caution! Gas can be hazardous to health or lead to death!
a) Always keep a distance from the gas outlet.
b) When welding, pay attention to the exchange of air, avoiding gas inhalation.
c) Remove chemical substances (greases, solvents) from the surface of the workpieces as they
burn under high temperature, giving off poisonous fumes.
d) Welding galvanized parts is allowed only with efficient extraction with filtration and a supply
of clean air. Zinc vapors are very toxic, and the symptom of poisoning is the so-called zinc
fever.
5. Instructions for use
5.1. General
a) The device should be used in accordance with its intended purpose, in compliance with the
health and safety regulations and the restrictions resulting from the data on the rating plate
(IP level, duty cycle, supply voltage, etc.).
b) Do not open the unit as this will void the warranty; also, exploding exposed parts may cause
injury.
c) The manufacturer shall not be liable for technical changes of the equipment or material
damage resulting from the introduction of these changes.
d) If the equipment malfunctions, contact the service centre.
e) Do not cover the ventilation slots of the device - place the welder at a distance of 30 cm from
the surrounding objects.
f) The welder must not be held under the arm or close to the body.
g) Do not install the equipment in rooms with aggressive environment, high dustiness, and near
devices with high electromagnetic field emission.
h) Keep fingers, hair and clothing away from the rotating fan.
i) The appliance must be earthed during operation.
EN