Tractel Dynafor DMU Manual De Instalación, De Utilización Y De Mantenimiento página 13

_a
A
Product serial number
B Master radio address
C Slave radio address
D Memory used for saving
E Master configuration mode
F Acceleration value
G Manufacturer
9_b
H Software and hardware versions of the display unit
Sensor information:
A
Sensor radio address
B Manufacturer
C Date of latest calibration
D Date of next recommended calibration
E Software and hardware versions of the sensor
F Automatic zero value
G Sensor serial number
To return to the main menu, hold down (for one second)
the left button.
5.9.10. Parameters menu
A
The "Parameters" screen is entered by pressing the
B
§5.9.10
"OK" button briefly (item I, fig. 1) when the "Parameters"
icon is highlighted from the main menu.
C
D
E
F
A
G
H
A "Mode management" sub-menu (see section 5.9.10.1)
B "General" sub-menu (see section 5.9.10.2)
To return to the main menu, hold down (for one second)
the left button.
5.9.10.1. Mode management sub-menu
The "Mode management" sub-menu is entered by
§5.9.10.1
pressing the "OK" button briefly (item I, fig. 1) when the
"Mode management" icon is highlighted.
A
B
C
D
E
F
G
A Reading frequency, adjustable from 1 to 4 Hz
B Automatic sleep mode setting (not available for wired
sensors)
C Automatic power-saving mode setting (not available
for wired sensors)
D
Remote sensor sleep (not available for wired sensors)
E Remote sensor shutdown (not available for wired
sensors)
The navigation in the sub-menu is done by using the up
and down buttons. The round, blue indicator updates
according to the position.
The values are set by pressing the left and right buttons.
EN
B
A
B
C
D
E
13