VEVOR RP8626 Manual De Instrucciones página 25

9. Connect the other end of the High-Pressure Paint Hose (M) to the Gun Inlet
Port (V) on the spray gun Handle (T). Use a pair of wrenches to correctly tighten
the fitting
10. Connect the Suction Tube (J) and Primer Output Tube (H) to the back of the
valve housing, then install the Inlet Screen (K). Secure in place using the supplied
hose clamps.
11.Set the Pressure Control Knob (D) to the Prime/Clean position.
- 24 -