VEVOR RP8626 Manual De Instrucciones página 31

17. Move the Primer Output Tube (H) to the paint container and clip it to the
Suction Tube (J).
NOTICE: The motor will stop which indicates the pump and hose are primed with
paint and under pressure. If the motor continues to run, the sprayer is not
Correctly primed. To re-prime, turn the Spray / Prime Switch (F)to the Prime
position and repeat all the steps beginning at Step 9.
PAINTING
1. Set the Pressure Control Knob (D) to a medium -high pressure.
2. Test this pressure setting on a scrap piece of material.
- 30 -