Publicidad
Idiomas disponibles
Idiomas disponibles
Cannot trigger the spray
gun.
Paint is coming out of
the pressure control
knob.
Spray/Prime valve
actuates automatically
relieving pressure
through the Output
Prime Tube.
Paint leaks down the
outside of the pump.
Motor is hot and runs
intermittently. Motor
automatically shuts off
due to excessive heat.
Damage can occur if
cause is not corrected.
Spray gun trigger lock is
locked.
Pressure Control Knob is
worn.
System is over-pressurized. Have the sprayer serviced by a qualified repair
Pump packing seals have
worn.
Vent holes in motor
enclosure are plugged
or sprayer is covered.
Extension cord is too long
or not heavy enough
gauge.
Unregulated electrical
generator being used has
excessive voltage.
Rotate the trigger safety lever to the unlock
position.
Have the sprayer serviced by a qualified repair
person.
person.
Replace pump packing seals.
Keep vent holes clear of obstructions and
overspray, and keep the sprayer uncovered
and open to air.
Replace the extension cord with a 12 AWG
cord.
Use an electrical generator with a proper voltage
regulator. Sprayer requires a 120VAC, 60Hz,
1500-Watt generator.
- 55 -
Publicidad
