Audio Settings - Kenwood KDC-BT48DAB Manual De Instrucciones

AUDIO SETTINGS

While listening to any source...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [AUDIO CONTROL], then press the
knob.
3
Turn the volume knob to make a selection (see the following table),
then press the knob.
3
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
(or using RC-406)
1
Press AUD to enter [AUDIO CONTROL].
2 Press J / K to make a selection, then press ENT IW.
To return to the previous setting item or hierarchy, press
SUB-W LEVEL –15 to +15 (0) Adjusts the subwoofer output level.
BAND1 LEVEL –8 to +8 (+5):
BAND2 LEVEL –8 to +8 (+5):
Adjusts the level to memorize for each source. (Before
BAND3 LEVEL –8 to +8 (+4): making an adjustment, select the source you want to
adjust.)
BAND4 LEVEL –8 to +8 (+5):
BAND5 LEVEL –8 to +8 (+1):
PRESET EQ DRIVE EQ/ TOP40/ POWERFUL/ ROCK/ POPS/ EASY/ JAZZ/ NATURAL/
USER: Selects a preset equalizer suitable to the music genre. (Select [USER]
to use the customized BAND1 to BAND5 settings.)
[DRIVE EQ] is a preset equalizer that reduces noise from the road.
BASS BOOST LEVEL1 / LEVEL2 / LEVEL3: Selects your preferred bass boost level. ;
OFF: Cancels.
LOUDNESS
SUBWOOFER SET
LPF SUBWOOFER
SUB-W PHASE
HPF
.
Default: XX
FADER
BALANCE
VOLUME OFFSET
(Default: 0)
SOUND RECNSTR
(Sound
reconstruction)
[SUB-W LEVEL]/ [LPF SUBWOOFER]/ [SUB-W PHASE] is selectable only if
[SUBWOOFER SET] is set to [ON].
LEVEL1/ LEVEL2: Selects your preferred low and high frequencies boost
to produce a well-balanced sound at a low volume level. ; OFF: Cancels.
ON: Turns on the subwoofer output. ; OFF: Cancels.
THROUGH: All signals are sent to the subwoofer. ; 85HZ/ 120HZ/
160HZ: Audio signals with frequencies lower than 85 Hz/ 120 Hz/
160 Hz are sent to the subwoofer.
REVERSE (180°)/ NORMAL (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
(Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)
THROUGH: All signals are sent to the speakers. ; 100HZ/ 120HZ/
150HZ: Audio signals with frequencies higher than 100 Hz/ 120 Hz/
150 Hz are sent to the speakers.
R15 to F15 (0): Adjusts the rear and front speaker output balance.
L15 to R15 (0): Adjusts the left and right speaker output balance.
–8 to +8 (for AUX) ; –8 to 0 (for other sources): Presets the volume
adjustment level of each source. (Before adjustment, select the source
you want to adjust.)
ON: Creates realistic sound by compensating the high-frequency
components and restoring the rise-time of the waveform that are lost in
audio data compression. ; OFF: Cancels.
ENGLISH | 17