Measuring Ac, Dc Or Ac+Dc Current - Metrix MTX204 Manual De Instrucciones

2. Toggle between AC or DC voltage measurement by pressing the yellow
button (in VlowZ : only AC measurement available).
3. Connect the red test lead to the + terminal and the black test lead to the
COM terminal.
4. Measure the voltage by touching the probes to the desired test points of
the circuit:
To avoid to measure ghost voltage, choose
DMM is lower in Low Z (500 kΩ).
There are two ranges in the mV setting. As default, the 600 mV range is selected.
Pressing RANGE switches the instrument to 60 mV to measure weak voltages.
3.5.

Measuring AC, DC or AC+DC current

1. Turn the switch to
2. Toggle between AC or DC current measurement by pressing the yellow
key.
3. Connect the red test lead to either A, or mA/µA terminal and black test
lead to the COM terminal.
4. Break the circuit path to be measured. Then connect the test leads across
the break and apply power.
5. Read the measured current on the display.
Do not exceed the current limits: 10A in the 10A range and 630mA in the µA and mA
range.
MTX 204, 10A range
, , or .
, impedance of the
MTX 204, µA range
32