Driving The Scooter On Ramps; Operator Control - Vermeiren Ceres 3 Manual De Instrucciones

2.9

Driving the scooter on ramps

L
WARNING:
Risk of injury - Do not exceed the maximum load of the ramps.
L
WARNING:
Risk of injury - Choose the correct ramps so there cannot be caused any
injury or damage.
L
WARNING:
Risk of injury - Note that the considerable weight of the electric scooter
generated large reverse forces when an attendant is pushing the scooter over the
ramps.
L
WARNING:
Risk of injury - Be sure that the wheel height is high enough to get over the
free height of the ramps. The scooter frame may not touch the ramps.
Should you wish to use ramps to drive over an obstacle, please note the following:
1. Find out from the manufacturer what the maximum load is for the ramps.
2. Drive on the ramps at the lowest speed possible.
3. See the instructions in the chapter "your first trip".

2.10 Operator control


Put the ON/OFF key switch on.

The battery level indicator

Now turn the speed control (, ) to the desired driving speed.

Push the drive lever with your fingers toward the handle bars (right lever for forward movement,
left lever for backward movement).

To sound the horn, press the horn button

To put on the front and back lights, press the lights button

To put on the emergency flashers, press button

To put on the indicator lights, press the desired button
indicator).

To stop the scooter loosen the speed lever under the operator control.
Vermeiren is responsible for the changes in the software. For changes in the software contact
Vermeiren.

shows the current level of your batteries.

.

.
Page 15
Ceres 3, Ceres 4

.
 
and (left = left indicator, right = right
1 = Battery level indicator
2 = Speed control (slow)
3 = Speed control (fast)
4 = Speed switch
5 = Horn
6 = Emergency lights
7 = Lights (front and rear)
8 = Indicator (left)
9 = Indicator (right)
2015-03