Adjusting The Armrests; Tyre Changing - Vermeiren Ceres 3 Manual De Instrucciones

3.6

Adjusting the armrests

L
CAUTION: Risk of tipping over - Make sure that the armrests are positioned symmetrically
from the seat.
The width of the seat can be changed by adjusting the armrests.
Loosen the starknobs at the back of the seat frame, then adjust the armrest by sliding the armrest.
Once satisfied with the width, tighten the starknob.
3.7

Tyre changing

L
CAUTION: There must be no air in the tube before it can be removed.
L
CAUTION: Risk of damage - If handled improperly, the rim might be damaged.
Note the following before inserting the new tube:
Check the rim bed and the inside wall of the tyre for foreign matter and clean these properly if
necessary. Check the condition of the rim bed, especially around the position of the air valve. Please
use only genuine original replacement parts. No liability is accepted for damage caused by non-
genuine replacement parts. Kindly contact your specialist dealer.
Assembly:
L
WARNING: Risk of injury - Check that the pressure is correct.
L
CAUTION: Risk of injury - Make sure that no objects or body parts are pinched between the
tyre and the rim when mounting a tyre.
L
WARNING: Risk of injury - Make sure all screws are firmly secured by hand before driving
with your scooter. Screw adhesive (ex. Loctite) should be applied to the screws on the
flange. Screw adhesive will only work if the thread is free of grease and particles.
ASSEMBLY
Insert the partly-filled inner tube into the tyre.
1. Connect the two sides of the rim ,  through the tyres and place the flange against the tyre and
screw them back again with the 4 screws .
2. Put the air valve through the hole for it in the rim.
3. Put the wheel , , ,  and flange  back on the scooter and secure these connection with the
middle screw . Inflate the wheel to the recommended tyre pressure.
Check all around on both sides that the tube is not pinched between the rim and the edge of the tyre.
Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned properly
in the region of the air valve.
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equidistant from the edge of the
rim on both sides of the tyre, then the tyre is centered properly. If not - let out the air and position the
tyre afresh. Now the tyre can be inflated to its full operating pressure (note the maximum) and the
valve cap should be replaced.
DISMANTLING
1. Unscrew and remove the middle screw
 that attach the wheel , , ,  and
flange  to the scooter.
2. Let the air out of the wheel by lightly
pressing the pressure pin on the valve.
3. Unscrew the 4 screws  of the rim to
separate the rim sides ,  and flange
.
Page 21
Ceres 3, Ceres 4
2015-03