Settings; Setting The Camera Output - Abus TVVR30004 Manual De Instrucciones

Live view

Settings

Note
The live view can be set as follows.
Open the main menu, then click on "Configuration". Then
click on "Liveview":
The following settings are available in the TAB "General":
Video Output In- VGA/HDMI, Main CVBS
terface
Select the connection where the set-
tings are changed
Different camera layouts
Live View Mode
Switching time between the individu-
Dwell Time
al cameras and the sequence dis-
play
Activate/deactivate the status bar
Display the status
bar
Allocate monitor for the output of
Event Output
events
in seconds, where the event on the
Full Screen Moni-
allocated monitor will be displayed.
toring Duration
in seconds, the duration of the Pop-
Post Event Dis-
up window when an event occurs.
play Time
Note
The BNC output can be used either for a spot
monitor or a separate monitor.
NoteVGA monitor connected:
A connected VGA monitor automatically becomes
the main monitor where the audio output is also
assigned. The BNC output Video Spot Out output
displays the cameras in sequence and in full
screen.
No VGA monitor connected
If during the boot process of the DVR the VGA cable is not
connected, the main video signal is displayed at BNC output .
Connect the VGA cable and reboot the DVR in order to display
the main video signal at the VGA output.
77

Setting the camera output

You can display a maximum of 4 cameras simultaneously
in the live view.
Click on the TAB "View".
1.
2. Select the display mode.

1 x 1

2 x 2
3. The camera signal is assigned to the corresponding
image section using the navigation keys.

"X" means that this camera is not displayed.
4. Click on Apply to accept the settings.