Console; Function Keys - Tunturi Cross sprinter Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38

Console

The power for the console is provided by 3 AA alkaline
batteries (provided) and will operate on rechargeable
NiCd AA batteries. Once the batteries are installed the
console will power on, the Time window will display the
total usage time, the Distance window will display the
total usage distance reading and the RPM window will
display the software version. The usage time shows how
long the elliptical has been in use and the distance shows
how many virtual miles the elliptical has gone.
If the console does not detect a speed signal, or key
activations, it will go to sleep to protect battery life. To
wake the console up you can press any key.

Function keys

1. Start/Stop: Starts and stops the program timer.
2. Time - (Down): Used to set workout time before the
start key is pressed. The down key will decrease the
time setting by 1 minute for each key press. The time
will change more rapidly when the key is held down
for 2 seconds. The key is also used to switch the time
reading to count down (remaining time).
3. Reset: Performs a complete reset of the console.
4. Time + (up): Used to set workout time before the start
key is pressed. The up key will increase the time
setting by 1 minute for each key press. The time will
change more rapidly when the key is held down for
2 seconds. The key is also used to switch the time
reading to count up (elapsed time).
Display
5. Time: Displays workout time two ways; either count
up (accumulated time) or count down (remaining
time), depending on your preference selected before
starting the timer.
6. RPM: Displays the current pedaling speed as Revoluti-
ons Per Minute.
7. Distance: Displays virtual distance traveled in miles
or kilometers (units selected through Management
Mode, see page 9 for details).
8. Heart Rate: Displays heart rate in beats per minute
when a heart rate chest belt transmitter is worn and
detected by the console. The heart rate receiver is
compatible with Polar coded transmitters.
Operation
Power the console on by pressing any key.
Enter Quick start operation by simply pressing the
start key. The time will count up from zero.
You may set a workout time by using the Time up
and down keys. When you press the Start key the
time will count down to zero from the set time. After
pressing start you can use the up and down keys to
switch the time to count up or count down.
Press the start/stop button to Pause the timer and also
to resume the timer when it is in Pause mode.
Press the Reset key to reset all the data.
For Heart Rate readings you must wear a heart rate
transmitter. The console will pick up the transmitter
signal and display your heart rate automatically.
Cross sprinter
3

Publicidad

Tabla de contenido
loading

Tabla de contenido