Bobbin winding
(continued)
[]
Push the bobbin to the right,
[] With free end of the thread held in your hand, depress the
foot control. Stop the machine when it has made a few turns,
and cut the thread close to the hole in the bobbin.
[] Depress the foot control again° When the bobbin is fully
wound, it stops automatically. Return the bobbin winder to its
original position by moving the spindle to the left and cut the
thread.
[][]
[]
1
[]
Push the handwheel to the left to engage clutch°
*The machine does not function until the clutch is
engaged.
NOTE: Position of the bobbin winder stopper is adjustable for
the required amount of thread on bobbin (example 1/2
full or full etc_)Use a screwdriver and loosen the screw
one turn or less to adjust the position of the bobbin winder
stopper_ Do not take out the screw all the way-
[]
pt
2O