General Safety Instructions; Machine-Related Safety Instructions - Festool RAP 80.02 E Manual De Instrucciones

Rotary polisher
Technical specifi cations
Power
Rotational speed
Polishing pad
Connecting thread of drive shaft
Weight (without cable)
Protection class
The specifi ed illustrations are at the beginning of
the Operating Instructions.
Graphical symbols
Caution. Danger!
Wear a dust mask!
Wear protective goggles!
Wear ear protection!
Read the Operating Instructions/Notes!
1 Intended use
The machine is designed for polishing painted
surfaces.
To guarantee electrical safety, the machine must
not be damp nor operated in a damp environment.
The user bears the responsibility for dam-
age and accidents caused by improper
use.
2 Safety instructions
2.1

General safety instructions

WARNING! Read all safety warnings and
all instructions. Failure to follow the warn-
ings and instructions may result in electric shock,
fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
• Never allow children to use the machine.
2.2

Machine-related safety instructions

- This power tool is intended to function as a
polisher. Read all safety warnings, instructions,
illustrations and specifi cation provided with
this power tool. Failure to follow all instructions
listed below may result in elektric shock, fi re and/
or serious injury.
- Operations such as grinding, sanding, wire
RAP 80.02 E
brushing or cutting-of are not recommended to
500 W
be performed with this power tool. Operations
750 – 2300 rpm
for wich the power tool was not designed may
up to dia. 80 mm
create hazard and cause personal injury.
M 14
- Do not use accessories which are not specially
1.6 kg
designed and recommended by Festool. Just
/ II
because the accessory can be attached to your
power tool, it does not assure safe operation.
- The rates speed of the accessory must be at
least equal to the maximum speed marked in
the power tool. Accessories running faster than
their rated speed can break and fl y apart.
- The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
- Threaded mounting of accessories must match
the grinder spindle thread. For accessories
mounted by flanges, the arbour hole of the
accessory must fit the locating diameter of
the fl ange. Accessories that do not match the
mounting hardware of the power tool will run
out of balance, vibrate excessively and may cause
loss of control.
- Do not use a damaged accessory. Before each
use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad for
cracks, tear or excess wear, wire brush for
loose or cracked wires. If power tool or acces-
sory is dropped, inspect for damage or install
an undamaged accessory. After inspecting and
installing an accessory, position yourself and
bystanders away from the plane of the rotating
accessory and run the power tool at maximum
no-load speed for one minute. Damaged acces-
sories will normally break apart during this test
time.
- Wear personal protective equipment. Depend-
ing on application, use face shield, safety gog-
gles or safety glasses. As appropriate, wear dust
mask, hearing protectors, gloves and workshop
apron capable of stopping small abrasive or
workpiece fragments. The eye protection must
be capable of stopping fl ying debris generated by
various operations. The dust mask or respirator
must be capable of fi ltrating particles generated
by your operation. Prolonged exposure to high
intensity noise may cause hearing loss.
- Keep bystanders a safe distance away from
work area. Anyone entering the work area must
wear personal protective equipment. Fragments
10