Gardena C 2030 duo plus Manual De Instrucciones página 23

1874-20.960.01_02.07.2011_GARDENA.qxp 18.07.2011 12:44 Seite 23
Activate / deactivate
watering programme :
[Level 6]
3.
4.
5.
The Prog ON must be selected so that the watering programme
OFF
can start. With Prog
ON OFF
Prog / can be independently selected for each valve.
Also with Prog OFF manual watering is possible.
ï
1. Select Valve 1 ( V1) or Valve 2 (V2
- button (V1 / V2) (if a programme was previously created
then the valve cannot be selected, the corresponding valve is
automatically selected).
2. Press Menu button 5 times [Level 6] (not necessary if a
programme was previously created).
ON
3. Select Prog or Prog
confirm with the OK button.
For 2 sec. Prog OK is shown and then the display moves to
the Normal Display [Level 1] .
ON
Prog : The water computer has now been programmed, i.e. the
inbuilt valve opens and closes completely automatically and thus
waters at the programmed time.
B) Direct sensor control
Prerequisite : at least one GARDENA Soil Moisture Sensor is
connected (see 4. Initial Operation). Watering nights (20:00 –
06:00), if the sensor registers dry.
A previously set scheduled watering programme is stored but
not carried out.
1. Select programme for Valve 1 (
with the - buttons (V1/ V2).
2. Press Menu button 3 times.
Run Time and the watering duration flash on the display.
3. Set watering duration hours with the
0
hours) and confirm with the OK button.
Run Time and the watering duration minutes flash on
the display.
4. Set watering duration minutes with the
10
minutes) and confirm with the OK button.
Watering cycle flashes on the display.
5. Select direct sensor control
confirm with the OK button.
After each watering, a 2-hour watering pause is triggered in
order for the Soil Moisture Sensor to record the soil moisture.
automatic watering is deactivated.
ð
) with the
OFF
with the - buttons and
:
ï
V1) or Valve 2 (V2
- buttons (e.g.
- buttons (e.g.
with the - buttons and
ð
)
23