Tabla de contenido
Publicidad
WARNING:
Incorrect combinations of grinding wheel, wheel guard and tool speed could result in injury.
Correct combinations are specified below:
Guard Part Number
88H60–961A
99H45–981
LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
USA No. : C31–06–G00
Where lubricators cannot be permanently mounted, we
recommend using an Ingersoll–Rand No. 8LUB12
Lubricator.
Before starting the tool, unless an air line lubricator is
used, detach the air hose and inject about 1.5 cc of
Ingersoll–Rand No. 50 Oil into the air inlet. Remove the
Oil Chamber Plug and fill the chamber.
After each 8 hours of operation, or as experience
indicates, remove the Oil Chamber Plug and fill the
chamber.
Model
Free Speed
99HL45H108
99HL60H106
99HL60H108
99HG45H108
99HG60H106
GRINDER SPECIFIC WARNINGS
Wheel Type
1
1
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 28
HOW TO ORDER A GRINDER
HORIZONTAL GRINDER with LEVER THROTTLE
rpm
inches
4 500
8
6 000
6
6 000
8
HORIZONTAL GRINDER with GRIP HANDLE
4 500
8
6 000
6
Wheel Diameter
Maximum Wheel
in. (mm)
6 (152)
8 (203)
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Type 1 Wheel
mm
203
152
203
203
152
3
Maximum Speed
Thickness
in. (mm)
1 (25.4)
1 (25.4)
FILTER
COMPRESSOR
(Dwg. TPD905–1)
Spindle and Guard
5/8"–11
5/8"–11
5/8"–11
5/8"–11
5/8"–11
rpm
6 000
4 500
8"
6"
8"
8"
6"
Publicidad
Tabla de contenido
