stayer SCR315W Manual De Instrucciones página 46

Use of the extensions for supporting the
work piece
The machine has two telescopic extensions 56 to
improve the support of large work pieces on the
machine. Adjust the separation of the extension by
unlocking its guides by means of button 57.
Preparing the inclined horizontal cut on the
lower table
IMAGE C
For greater easiness, the lower cutting table has a
continuous cutting angle adjustment and 11
predetermined positions by locking at the following
angles:
+60º, +45º, +30º, +22.5º, +15º, 0º, -15º, -22.5º, -30º,
-45º, -50º
Selection of the angle is carried out by means of a
grip system with locking 13.
1. Unlock the cutting table 15 by lifting grip 13-A.
2. Unlock grip 13 keeping button 13-B pressed.
3. Move grip 13 until achieving the desired miter
angle and release button 13-B.
4. Lock table 15 by pushing in grip 13-A.
Preparing the inclined vertical cut on the
lower table
B C D E
IMAGES
For carrying out inclined cuts vertically, there are
two butt inclinations that are calibrated and
predetermined at 0º and 45º. Use the goniometer to
adjust to intermediate angles.
1. Loosen the vertical locking arm 28.
2. Select the cutting angle using the integrated
scale 35.
3. Tighten the vertical locking arm 28.
4. Check that the upper table 38 does not collide
with the upper movable guide stop 49. If so,
move the movable stop 49 by means of the
stop's two rear screws until it does not anymore
disturb the descent of the head.
ENGLISH
44
Preparing the cutting stop on the lower
table
IMAGE
1. Loosen screw 7.
2. Introduce the cutting stop 9 into the screwed
3. To avoid slipping, tighten screw 7 ensuring that
Carrying out the cutting operation on the
lower table
IMAGES
1. Prepare the piece to be worked on by fastening it
2. If you will make a radial cut, enable the
2. Start the machine pursuant the starting
3. Wait for some seconds until the cutting disk
4. Slowly lower the operating head by aid of grip 3
5. Make the cut by exercising gentle pressure Do
J K
6. Once the cutting operation has been completed,
7. Stop the machine in accordance with the
44
A
insertion opening 23.
the bar bearing the safety bore.
B C D
in a completely safe manner. Use clamps and
the standard pusher stick supplied with the
equipment.
horizontal movement of the head by releasing
the telescopic guides 41 and first loosening
butterfly nut 48.
instructions in this manual.
reaches its maximum speed.
in a continuous, slow way and without sudden
pulls.
not force the machine 3. If you are making a
radial cut, start making the cut from the outer
area of the work piece with a gentle and
adequate intensity for the material to be cut.
lift the operating head again.
stopping instructions in this manual.