stayer SCR315W Manual De Instrucciones página 47

Use as circular saw by means of the upper
cutting table
¡Warning!
It is obligatory to adequately prepare the machine
before any operation on the upper cutting table.
Preparing the upper table
IMAGES
B C D E
Preparing the height of the upper cutting
table
Information:
The upper cutting table can be regulated in height
from 0 to 54 mm.
¡Warning!
The height of the upper cutting table with regard to
the cutting disk must be such that from the work
piece to be cut there only stands out a height that is
equal to that of the cutting tooth.
1. Make sure that the machine is in the horizontal
resting position by lowering the head and
locking it by inserting grip 32 in its retainer hole.
Lock telescopic guides by tightening guide
butterfly nut 48.
2. Loosen butterfly nuts 40.
3. Adjust the height of the table 38 by gently pulling
or pushing the table itself.
4. Secure an exact straight cut (90º) by leveling the
table using a water level.
5. Tighten butterfly nuts 40.
Preparing the cutting width on the upper
table by means of a guide
1. Release the movement of parallel guide 44 by
lowering its fastening rod.
2. Adjust the cutting width by moving guide 44 over
the guide with a graduated scale 43.
3. Secure guide 44 by lifting its fastening rod.
ENGLISH
45
Carrying out the cutting operation on the
upper table
1. Make sure that the machine is in the horizontal
2. For longitudinal cuts you can employ the parallel
3. Push the work piece by means of the standard
I
4. Start the machine in accordance with the
5. Wait for some seconds until the cutting disk has
6. Approach the work piece to the cutting disk with
7. Push the work piece gently with an intensity that
8. Stop the machine in accordance with the
13.Precautions and use of
protective clothing
This electric tool may be used only by adult
personnel having the necessary education and
training, in compliance with the thereto related
legislation and what is provided in respect of the
prevention of labor hazards for your company and
your job. Additionally, the operator of the electric
tool must have understood, assimilated and
completely comply with this manual.
This machine requires the use of the following
individual protective equipment:
1. Safety helmet.
2. Integral face-protecting equipment (eyes and
3. Ear protectors.
4. Dusk mask.
5. Protective gloves against mechanical
6. Boots with toe cap and insole.
7. Working clothes.
8. Tool bag.
9. Safety belt.
45
resting position by lowering the head and
locking it by inserting grip 32 in its retainer hole.
Lock telescopic guides by tightening guide
butterfly nut 48.
guide for supporting the work piece.
pusher stick whenever possible.
instructions for starting the machine in this
manual.
reached its maximum speed.
utmost care keeping your hands away from the
cutting path.
is adequate for the characteristics of the
material.
instructions for stopping the machine in this
manual.
face) against impacts.
aggression.