Lift Master Forms; Manufacturer; Purpose; Changes To The Design / Construction - Nussbaum POWER LIFT HL 2.50 NT Instrucciones De Servicio

9

Lift master forms

9.1

Manufacturer

Otto Nußbaum GmbH & Co.KG
Korker Straße 24
D-77694 Kehl-Bodersweier
9.2

Purpose

The lift is a lifting tool for raising motor vehicles in normal workshop operation. A total weight of max. 5.000
kg for a maximum load distribution of 3:1 or 1:3 in the drive in direction or against the drive-in direction may
not be exceeded. Single loading of the carrier arm may not occur.
Set up of the standard lift in explosion endangered workshops and humid spaces (e.g. washing halls) is
prohibited. This is only possible with custom equipment.
Lift operation is done directly on the operating column.
After construction and maintenance changes on load carrying parts the lift must be inspected afterwards
by a specialist who approves the changes. If the set up location is changed, the lift must be checked
again by a specialist and changed approved.
Carrier arm variants
POWER LIFT HL 2.50 NT
9.3

Changes to the design / construction

Inspections by a technical expert are required before recommissioning (date, type of change, technical
expert signature).
..................................................................................................................................................................................
..................................................................................................................................................................................
Name, address of technical expert
......................................................................................
Location, date
9.4

Changing the assembly location

Inspections by a technical expert are required before recommissioning (date, type of change, specialist
signature).
..................................................................................................................................................................................
..................................................................................................................................................................................
Name, address of technical expert
......................................................................................
Location, date
20110002 POWER LIFT HL 2.50 NT - HYMAX HL 5000 PH OPI
Standard arm and
Standard arm
extension 220 mm
778-1213 mm Max. 1433 mm
Version 1.0
Double swivel arm
(DG)
Max. 1825 mm
...................................................................................
Technical expert signature
...................................................................................
Technical expert signature
Universal
860-1850 mm
69