Checking/Replacing Battery(Ies) Of Remote Control - Num'axes CANICOM 800 Expert Manual De Instrucciones

C hecking/replacing battery(ies) of remote control

Performance (radio range) of the remote control may deteriorate as batteries become weak. Be prepared
to replace the battery(ies).
To check the condition of the battery, turn on the remote control and look at the battery level indicator on
the LCD screen. The symbols which appear indicate the following:
Battery fully charged
Weak battery: prepare to replace the battery
Dead battery: your product functions in safety mode and the system locks up. The battery must be replaced.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate or may not be completely compatible
with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Remove the old battery(ies) and replace it(them):
- 1 3-V Lithium CR2 battery for the CANICOM 800 Expert remote control
- 2 alkaline LR06 AA batteries for the CANICOM 1200 Expert remote control
Replace the battery(ies) as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover (ref. Diagram 9 or
Diagram 10).
- Remove the old battery(ies).
- Insert the new battery(ies) paying attention to follow polarity indicated on the battery housing.
- Put the battery cover back in place and retighten the screw.
- Check the remote control operates correctly.
Diagram 9
Replacing battery of
CANICOM 800 Expert
remote control
WARNING
Make sure the
polarity is correct
Gb - 28
Diagram 10
Replacing batteries of
CANICOM 1200 Expert
remote control
WARNING
Make sure the
polarity is correct