Checking/Replacing Battery Of Remote Control - Num'axes EXPERT 600 Manual De Instrucciones

Checking/replacing battery of remote control


Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be
prepared to replace the battery.
To check the condition of the battery, turn on the remote control and look at the battery level indicator
on the LCD screen. The symbols which appear indicate the following:
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your EXPERT 600 switches to safety mode and the system locks up.
The battery must be replaced.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be completely compatible
with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Replace the battery as follows:
- on the back of the remote control, use a coin to turn the battery cover counter-clockwise and remove
it (ref. Diagram 6)
- remove the old battery
- insert the new battery (lithium 3V CR2) paying attention to follow polarity indicated on the battery
housing
- put the battery cover back in place making sure the seal is in the correct position in the remote control
(ref. Diagram 6)
- use a coin to close the battery cover
- check that the remote control operates correctly
then slightly incline
the coin to remove it.
Diagram 6
Use a coin to turn
the battery cover
counter-clockwise
Gb - 26
Make sure the polarity is correct
Polarity « - » of the battery
Make sure the seal is in
the correct position inside
the remote control before
replacing the battery cover
Polarity « + » of the battery
WARNING