General Settings - Psm - JVC KD-AR770 Manual De Instrucciones

Indication, [Range]
BAS* 1 (bass), [–06 to +06]
Adjust the bass.
TRE* 1 (treble), [–06 to +06]
Adjust the treble.
FAD* 2 (fader), [R06 to F06]
Adjust the front and rear speaker balance.
BAL* (balance), [L06 to R06]
3
Adjust the left and right speaker balance.
LOUD* (loudness), [LOUD ON or
1
LOUD OFF]
Boost low and high frequencies to produce a
well-balanced sound at low volume level.
SUB. W* 4 (subwoofer), [00 to 08]
Adjust the subwoofer output level.
VOL (volume), [00 to 30 or 50*
Adjust the volume.
* When you adjust the bass, treble, or loudness,
1
the adjustment you have made is stored for
the currently selected sound mode (C-EQ)
including "USER."
* 2 If you are using a two-speaker system, set the
fader level to "00."
* 3 This adjustment cannot affect the subwoofer
output.
* This takes effect only when a subwoofer is
4
connected.
* Depending on the amplifier gain control
5
setting. (See page 16 for details.)
14
General settings — PSM
You can change PSM (Preferred Setting Mode)
items (except "SID") listed in the table that
follows.
1
2
3
5 ]
4
5
Select a PSM item.
Ex.: When you select "DIMMER"
Adjust the PSM item selected.
Repeat steps 2 and 3 to adjust the
other PSM items if necessary.
Finish the procedure.