Automatic Washing/Drying Cycle - Teka LSI5 Guía De Uso

8. AUTOMATIC
WASHING/DRYING
CYCLE
You cannot exceed the maximum
dryable load of laundry indicated in
the programme table, otherwise the
laundry will not be dried satisfactory.
- Washing
l
Open the drawer and put in the correct
amount of detergent.
l
Refer to the list of washing programmes
for the fabrics to be washed (e.g. very
dirty cotton) and turn the selector knob to
the required programme.
l
Adjust the wash
necessary.
l
Press the option buttons (if required).
l
Check that the tap is turned on and that
the discharge
correctly.
- Drying
l
Select the degree of dryness that you
require:
EXTRA DRY
(suitable for towels, bathrobes and
bulky loads).
IRON DRY
(that leaves the laundry ready for
ironing).
CUPBOARD DRY
(for items that will be put away
without ironing).
l
Press the START/PAUSE button.
l
At the end of the wash phase the display
will show the drying time remaining.
temperature
hose is positioned
l
When the programme is finished the word
"End" will appear on the display. After 5
minutes the appliance will go into
standby mode (on certain models, the
display will show two lines).
l
Switch off the machine by turning the
programme selector to the OFF position.
l
Open the door and remove the laundry.
l
Turn off the tap.
CANCELLING THE DRYING PROGRAMME
l
To cancel the drying programme, press
and hold the DRYING SELECTION
button for about 3 seconds.
if
WARNING:
After cancelling the drying programme,
the cool down phase will begin and you
must wait for about 10/20 minutes
before opening the door.
In order to ensure the correct operation
of the appliance, it is advisable not to
interrupt the drying phase unless it is
absolutely necessary.
26