Teka LSI5 Guía De Uso página 5

The final part of a washer dryer
l
cycle occurs without heat (cool
down cycle) to ensure that the
items are left at a temperature
that ensures that the items will
not be damaged.
WARNING:
never stop a washer dryer before
the end of the drying cycle
unless all items are quickly
removed and spread out so that
the heat is dissipated.
After installation, the appliance
l
must be positioned so that the
plug is accessible.
The appliance must not be
l
installed behind a lockable
door, a sliding door or a door
with a hinge on the opposite
side to that of the washer
dryer, in such way that a full
opening of the washer dryer
door is restricted.
The maximum load capacity of
l
dry clothes depends on the
model used (see control panel).
The appliance is not to be used
l
if industrial chemicals have
been used for cleaning.
Do not dry unwashed items in
l
the washer dryer.
Items that have been soiled with
l
substances such as cooking oil,
acetone, alcohol, petrol, kerosene,
spot removers, turpentine, waxes
and wax removers should be
washed in hot water with an extra
amount of detergent before being
dried in the washer dryer.
Items such as foam rubber
l
(latex foam), shower caps,
waterproof
backed articles and clothes or
pillows fitted with foam rubber
pads should not be dried in the
washer dryer.
Fabric softeners, or similar
l
products, should be used as
specified by the fabric softener
instructions.
Oil-affected items can ignite
l
spontaneously, especially when
exposed to heat sources such
as a washer dryer. The items
become warm,
oxidation reaction in the oil,
Oxidation creates heat. If the
heat cannot escape, items can
become hot enough to catch
fire. Piling, stacking or storing
oil-effected items can prevent
heat from escaping and so
create a fire hazard.
If it is unavoidable that fabrics
l
contain vegetable or cooking
oil or have been contaminated
5
textiles, rubber
causing an