Vacuum Sweeper; Chapter 1 General Information; Chapter 2 Purposes / Intended Use; Chapter 3 Preparation (Unpacking) Page - Columbus KS 51|BM 45 Manual De Instrucciones

Vacuum Sweeper

KS 51|BM 45 – KS 71|BM 60
________________________________________________________________________________________
BEFORE USING THE MACHINE, READ THIS INSTRUCTION MANUAL CAREFULLY
_________________________________________________________________________________________
„columbus" DISCLAIMS ALL LIABILITY FOR DAMAGE TO THINGS AND / OR INJURY TO PERSONS RESULTING FROM FAILURE TO COMPLY
WITH THE INSTRUCTIONS IN THIS MANUAL AND FROM INCORRECT AND / OR IMPROPER MACHINE USE.
ALL THE EQUIPMENT NEEDED FOR PERSONAL PROTECTION (GLOVES, MASKS, WHITE-LENS GLASSES, KEYS, TOOLS, ETC.) MUST BE
ALWAYS KEEP THIS MANUAL HANDY FOR QUICK REFERENCE (IN CASE OF LOSS, ASK YOUR DEALER FOR ANOTHER COPY)
„columbus" RESERVES THE RIGHT TO MAKE CHANGES OR UPGRADE ITS MACHINES, WITHOUT ANY OBLIGATION TO UPGRADE
As per directive EC, every machine is supplied with a manual for its use and maintenance. Should this documentation result missing, the user is
kindly requested to order it.
Every machine is accompanied by the following documentation:
- Handbook for use and maintenance
- Declaration of conformity to directive EC.
With the aim of using the machine correctly and with maximum safety, the user must carefully read this entire manual, paying particular
attention to the sections regarding potential risks, safety regulations and emergency operations.
All the articles for the personal protection of the operator, specifically indicated in the manual, (gloves, masks, glasses, etc.) must be supplied
by the user. The terms front, rear, left and right used in this publication always refer to the driving position occupied by the operator.
To assure the longest possible life of the machine parts, the instructions in this handbook must be followed closely and only original spare parts
must be used. Data contained in this documents are liable to change since the Manufacturer reserved the right, in any given moment, to make
modifications with the aim of improving the machines.
UNPACKING:
Having eliminated the outer packaging, free the machine from the pallet as follows:
1) Release the front wheel brake
2) Remove the sticky tape Detail C blocking the handlebar
3) Open the waste container Detail A and pull out the two handlebar supports Detail B Fig.1
4) Screw the handlebar supports Part. B into the holes Part. E Fig. 1
5) Screw the ends of the handle into the holes Detail D on the supports as shown in Fig.1/B
6) Take the machine off the pallet: according to the machine weight, written on the CE label, this can be done in different ways:
a) Check the weight in kilograms on the CE plate and with the help of one or more persons, wearing protective gloves, lift the machine
by gripping the handle and under the front plastic cover and place it on the ground, being careful to not damage the flaps. With the
PROVIDED BY THE USER. FOR EASIER READING, REFER TO THE CONTENTS PAGE.
PREVIOUSLY- SOLD MACHINES.
ALL „columbus" SWEEPERS CONFORM TO EEC STANDARDS AND ARE LABELLED:
19
CHAPTER 1 – GENERAL INFORMATION
CHAPTER 2 – PURPOSE OF THE SWEEPER
CHAPTER 3 - PREPARATION