ALFRA ROTABEST RB 35 SP Manual De Instrucciones página 5

Device description
The magnetic core drilling machine can be attached to ferromagnetic workpieces using a mechanically switchable
permanent magnet. For this purpose, the magnet lever must be pressed downwards and the safety tab must latch
into place correctly. The motor can be switched on and off using the large keys on the operator panel. The LEDs on
the motor operating panel and the machine clearly indicate the operating state of the motor and the magnet's
holding force. A self-adjusting dovetail guide which the motor is attached to can be vertically adjusted using the star
handle. The type plate and an attachment possibility for the Allen keys included can be found on the back of the
machine.
A) Drive motor
B) Weldon tool holder
C) Slide and setting screws for adjustment on the back
D) Magnetic foot
E) Recess for safety belt
F) Mains cable
G) Safety tab
H) Operating panel
I) Lever for magnet
J) Star handle
1 – Motor ON
2 – LED for motor control
3 – Motor OFF
4 – Magnetic lever ON
5 – LED for magnetic field sensor
6 – Magnetic lever OFF
5