Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up
You received a completely assembled magnetic core drilling machine and detailed operating manual. Please check
the condition of the goods on receipt for any transport damage, and make sure the delivery is complete. Otherwise
contact the manufacturer immediately.
Always Read The Operating Manual Before Using The Device For The First Time!
1.
First, check the cable and plug for damage and insert the plug in the main socket.
2.
Insert the core drill in the tool holder on the working spindle of the motor and check that the bit is stable and
properly positioned. See back.
3.
Check that the magnet lever is pointing upwards and the switchable permanent magnet is deactivated so that
you can position the machine. A slight magnetic pre-tension helps with alignment of the machine on vertical
walls or for overhead work. Secure the drilling unit using the safety belt when working on walls and ceilings.
4.
Press the lever down as far as it will go and make sure that the safety tab audibly latches into place.
5.
As soon as the sensor LED lights up green or flashes red you can activate the motor by pressing the MOTOR
ON key on the operating panel at the side.
6.
Turn the star handle to lower the motor and the rotating drill slowly to the workpiece. Ensure sufficient cooling
during the drilling process.
7.
When you have finished drilling, move the motor upwards and deactivate it by pressing the MOTOR OFF key
on the operating panel.
8.
Once the motor has come to a complete standstill, remove the swarf and the other drilling waste.
9.
To deactivate the permanent magnet, press the black safety tab inwards using the ball of your hand and lift the
lever up.
10. Then clean the underside of the magnet of swarf or any other residue stuck to it.
6
Publicidad
