Clock And Timers; Setting The Clock; Play Timer; Sleep Timer - Panasonic SC-PM602 Instrucciones De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Clock and timers

Setting the clock

This is a 24-hour clock.
1
Press [SETUP] repeatedly to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select "CLOCK" and then
press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.

Play timer

(Except for Bluetooth
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [R, T] to select the source you want to play
and then press [OK].
To start the timer
1
Press [SETUP] repeatedly to select "TIMER SET".
2
Press [R, T] to select "SET" and then press [OK].
"#" is shown.
To cancel, select "OFF".
The system must be switched off for the timer to
operate.
To check the setting
Press [SETUP] repeatedly to select "TIMER ADJ" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
• The timer starts at a low volume and increases gradually to
the preset level.
• The timer comes on at the set time every day if the timer is
on.
• If you switch off the system and then switch on again while
a timer is in operation, the timer will not stop at the end
time.
10
10
source)
®

Sleep timer

The sleep timer switches off the system after the set time.
1
Press [SETUP] repeatedly to select "SLEEP".
2
Press [R, T] to select the setting (in minutes) and
then press [OK].
To cancel, select "OFF".
Note:
• The remaining time is shown for a few seconds every
"SLEEP 1"
minute.
is always shown when only 1 minute
remains.
• The sleep timer can be used together with the play timer.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido