To Install And Remove The Husqvarna Connectivity Device - Husqvarna 585, 592 XP, 592 XPG Manuel Del Usuario

5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
7. Tighten the bar nuts finger tight.
8. Tighten the saw chain. Refer to
of the saw chain on page 31 for instructions.
9. Tighten the bar nuts.
Note:
Some models have only 1 bar nut.
To install and remove the Husqvarna
connectivity device
The Husqvarna connectivity device is an accessory that
enables digital services from the Husqvarna Fleet
™
Services and Husqvarna Connect apps. Instructions
on how to use the Husqvarna connectivity device are
found in the respective app.
Note:
The Husqvarna connectivity device has a built-
in battery that cannot be replaced. Replace the
Husqvarna connectivity device unit if it is necessary.
1. Remove the cylinder cover.
1471 - 001 - 18.02.2021
To adjust the tension
2. Put the Husqvarna connectivity device in the holder
for the Husqvarna connectivity device.
3. Attach the wires to the holder for the Husqvarna
connectivity device.
4. Put the holder for the Husqvarna connectivity device
on the air filter holder and install the 2 screws.
11