Cutting Operation - Hitachi Koki C 10FCD Manual De Instrucciones E Instrucciones De Seguridad

English
3. Using the vise assembly (Optional accessory)
Base

4. Cutting Operation

a b
a b
Marking Marking
(pre-marked) (pre-marked)
(Front View)
CAUTION:
WARNING:
5. Miter cutting procedures
Miter Handle
NOTE:
* Positive stops are provided at the right and left of the 0° center setting, at 15°, 22.5°, 31.6°, and
45° settings.
Check that the miter angle scale and the tip of the indicator are properly aligned.
* Operation of the power tool with the miter angle scale and indicator out of alignment, or with
the miter handle not properly tightened, will result in poor cutting precision.
16
Vise
Assembly
Fig. 20
Adjusting Line
a b
Workpiece
Table Insert
Fig. 21
* Increased pressure on the handle will not increase the cutting speed.
On the contrary, too much pressure may result in overload of the motor and/or
decreased cutting efficiency.
* If the handle is pressed down with excessive or lateral force, the saw blade may
vibrate during the cutting operation and cause unwanted cutting marks on the
workpiece, thus reducing the quality of the cut. Accordingly, press the handle down
gently and carefully.
* Confirm that the trigger switch is turned OFF and the power plug has been removed
from the receptacle whenever the tool is not in use.
Miter Angle
Scale
Indicator
Spring
Plate
Tighten
Loosen
Turn the
Table
Fig. 22
(1) The vise assembly can be mounted on either the
left side base or the right side base, and can be
moved back and forth according to the width of the
workpiece.
Insert support of vise assembly into the hole located
on either the left side base or the right side of the
base as shown in Fig. 20.
(1) As shown in Fig. 21 the width of the saw blade is the
width of the cut. Therefore, slide the workpiece to the
right (viewed from the operator's position) when
length b is desired, or to the left when length a is
desired.
(2) Once the saw blade reaches maximum speed, push
the handle down carefully until the saw blade
approaches the workpiece.
(3) Once the saw blade contacts the workpiece, push the
handle down gradually to cut into the workpiece.
(4) After cutting the workpiece to the desired depth, turn
the power tool OFF and let the saw blade stop
completely before raising the handle from the
workpiece to return it to the full retract position.
(1) Loosen the miter handle and push the spring plate.
(2) Adjust the table until the indicator aligns with the
desired setting on the miter angle scale as shown in
Fig. 22.
(3) Re-tighten the miter handle to secure the table in the
desired position.