Maintenance Schedule - Husqvarna 143AE15 Manual De Instrucciones

Maintenance schedule

The following is a list of the maintenance that must be performed on the machine. Most of the items are described in the
Maintenance section. The user must only carry out the maintenance and service work described in this Operator's
Manual. More extensive work must be carried out by an authorized service workshop.
Maintenance
Clean the outside of the machine.
Check that the handle and handlebar are undamaged and
secured correctly.
Check that the stop switch works correctly.
Check that the cutting attachment does not rotate at idle.
Clean the air filter. Replace if necessary.
Check the cutters. Never use cutters that are blunt, cracked or
damaged.
Check that nuts and screws are tight.
Check that there are no fuel leaks from the engine, tank or fuel
lines.
Check the starter and starter cord.
Check that the vibration damping elements are not damaged.
Clean the outside of the spark plug. Remove it and check the
electrode gap. Adjust the gap to 0,6-0,7 mm or replace the spark
plug. Check that the spark plug is fitted with a suppressor.
Clean the machine's cooling system.
Clean the outside of the carburettor and the space around it.
Check the oil level of the gear box, and top up if necessary.
Clean the muffler.
Check the fuel filter from contamination and the fuel hose from
cracks or other defects. Replace if necessary.
Check all cables and connections.
Check the clutch, clutch springs and the clutch drum for wear.
Replace if necessary by an autorized service workshop.
Replace the spark plug. Check that the spark plug is fitted with a
suppressor.
18 – English
MAINTENANCE
Daily
maintenance
Weekly
maintenance
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Monthly
maintenance
X
X
X
X
X