Beper 90314 Manual De Instrucciones página 17

Food Processor Use instructions
Mill Fig. 5
Use the mill for milling herbs, nuts and coffee beans.
1 Put your ingredients into the jar. Fill it no more than half full.
2 Fit the sealing ring into the blade base.
3 Turn the blade base upside down. Lower it into the jar, blades down.
4 Screw the blade base onto the jar until it is finger tight.
5 Place the mill onto the power base and turn to lock .
6 Switch on to maximum speed or use the pulse control.
7 After milling, you can replace the blade unit with the sprinkler lid and shake out your food.
▲To ensure the long life of your machine, not allowed to continuously use more than 1 mi-
nute. Should cool down the motor at least 30 minute before next operation.
Slicer / Julienne / Potato chipper / Shred discs Fig. 6
Use the Slicer for cheese, carrots, potatoes, cabbage, cucumber, courgette, beetroot and onions.
Use the Julienne / Potato chipper disc for potatoes for Julienne style French fries; firm ingredients
for salads, garnishes, casseroles and stir fries
Use the shredding side for cheese, carrots, potatoes and foods of a similar
texture.
▲To ensure the long life of your machine, not allowed to continuously use more than 3 mi-
nute. Should cool down the motor at least 30 minute before next operation.
Before processed, please cut the meat into 3 X 3 cm Size. Never put more than 1000g such meat
into the container. After 1 minute, the meat will be processed finely.
Blender Fig. 7
1 Fit the sealing ring into the blade base and ensuring the seal is located correctly. Leaking will occur
if the seal is damaged or not fitted correctly.
2 Screw the jug onto the blade base.
3 Put your ingredients into the jug.
4 Put the filler cap in the lid, then turn.
5 Turn the lid in a clockwise direction to lock onto the jug
6 Place the liquidiser onto the processor base and turn to lock
7 Select a speed or use the pulse control.
8. Don't move the jug, lid and filler cap when the machine is working.
9. Max. 600 g carrots/0,9 L water is to be filled.
▲To ensure the long life of your machine, not allowed to continuously use more than 30 seconds,
should cool down the motor at least 3 minute, for 3 cycles.
Mini processor bowl Fig. 8
1 Fit the drive shaft and bowl onto the processor base.
2 Fit the mini processor bowl . Ensuring the ribs on the inside of the mini bowl chimney align with the
slots in the main bowl chimney .
3 Place the small knife blade over the drive shaft .
4 Add the ingredients to be processed.
5 Fit the lid and switch on. 17