Stihl SR 430 Manual De Instrucciones página 11

The bayonet fuel filler cap must be
closed with care after refuelling.
Screw Cap
WARNING
Unit vibrations can cause
an improperly tightened
fuel filler cap to loosen or
come off and spill quanti -
ties of fuel. In order to
reduce the risk of fuel
spillage and fire, tighten
the fuel filler cap by hand
as securely as possible.
Filling the Container
WARNING
Tighten all connections and check to be
sure the hose is securely attached and
in good condition. Keep the valve lever
on the control lever closed.
Before using the power tool with
chemicals, fill it with fresh water to
assure that you have it properly
assembled and practice spraying. Also,
check for any leaks at this time. When
thoroughly familiar with the power tool
operation, follow normal operating
procedures.
Fill your power tool in well-ventilated
areas, outdoors.
SR 430, SR 450
WARNING
Do not use:
flammables in the mistblower, which
–
can explode causing serious or fatal
injury;
caustic or corrosive materials in the
–
mistblower, that could result in
damage to the unit;
liquids with a temperature above
–
120° F (50° C) to avoid scalding and
damage to the unit.
To fill the container, place the power tool
on a level surface. To reduce the risk of
contaminating the surrounding
environment, be careful not to overfill the
container with chemical solution.
To reduce the risk of injury, do not fill the
unit while wearing it on your back.
If you fill the container with a hose
attached to a central water supply, be
sure the end of the hose is out of the
solution to reduce the risk of backflow,
i.e. the chemicals being sucked into the
water supply in the case of a sudden
vacuum.
Calculate the correct amount of
chemical solution so that it is used up at
one time, with no extra solution left in the
tank.
After filling, fit the container cap and
tighten it down firmly.
WARNING
Check for leakage while refilling and
during operation. A leak from the
container or a loose fitting could soak
your clothing and come into contact with
your skin.
Before Starting
WARNING
Always check your power tool for proper
condition and operation before starting,
particularly the throttle trigger and
setting lever with stop position. The
throttle trigger must move freely and
always spring back to the idle position.
Never attempt to modify the controls or
safety devices.
WARNING
Check fuel system for leaks, especially
the visible parts, e.g., filler cap, hose
connections, manual fuel pump (only for
power tools equipped with a manual fuel
pump). Do not start the engine if there
are leaks or damage – risk of fire! Have
the machine repaired by a servicing
dealer before using it.
WARNING
To reduce the risk of leakage and skin
contact with chemicals, check that the
container cap and all connections in the
path of the spray are tight, and be sure
the hose is securely attached and in
good condition. Keep the valve lever
closed.
WARNING
Never operate your power tool if it is
damaged, improperly adjusted or
maintained, or not completely or
securely assembled.
English
9