Dusting And Spreading Mode - Stihl SR 430 Manual De Instrucciones

Checking flow rate
Place the unit on the ground.
N
Fill the container with water up to
N
10 liter mark.
Machines without pressure pump
Set the standard metering knob to 6.
N
Start the machine.
N
Hold the spray tube horizontally, run
N
the engine at full throttle, spray the
contents of the container down to
the 5 liter mark and note the time
taken.
The time required to spray 5 liters fluid
should be between 75 and 105 seconds.
Machines with pressure pump
Set the 'pressure pump' metering
N
knob to 2.3.
Start the machine.
N
Hold the spray tube horizontally, run
N
the engine at full throttle, spray the
contents of the container down to
the 5 liter mark and note the time
taken.
The time required to spray 5 liters fluid
should be between 60 and 90 seconds.
In case of deviations:
Check the container, hose system,
N
metering knob and optional
pressure pump for contamination
and clean if necessary.
Check blower air intake and clean if
N
necessary.
Check engine setting and correct if
N
necessary.
SR 430, SR 450
If there is no improvement, contact your
dealer for assistance.

Dusting and Spreading Mode

SR 450 only.
Metering lever
A
1
B
1
The discharge rate is infinitely variable
with the metering lever (1).
Position A (metering lever vertical) –
N
feed closed
Position B (metering level parallel to
N
blower tube) – feed open
Discharge rates
The discharge rate is dependent on the
density and grain size of the product
used.
Granulate 0 - 9 kg/min
Powder 0 - 3 kg/min
English
27