Information Before You Start - Stihl SR 430 Manual De Instrucciones

English
Opening the threaded filler cap
Turn the cap counterclockwise until
N
it can be removed from the tank
opening.
Remove the filler cap.
N
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank.
Closing the threaded filler cap
Position cap.
N
Turn the cap clockwise as far as it
N
will go and tighten it as securely as
possible by hand.
20

Information Before You Start

NOTICE
With the engine stopped and before
starting, check the air intakes between
the backplate and powerhead for
blockages and clean if necessary.
Control handle
1
2
1 Setting lever
2 Throttle trigger
3 Throttle trigger lockout
Functions of setting lever
Run position F
Engine runs or is ready to start. Throttle
trigger (2) can be moved to any position.
Stop position 0
Ignition is interrupted, engine stops. The
setting lever (1) is not locked in this
position. It springs back to the run
position. The ignition is switched on
again.
Throttle trigger limiter position
Travel of throttle trigger can be limited in
two stages:
a 1/3 throttle
b 2/3 throttle
To disengage the travel limiter,
return the setting lever (1) to the run
N
position F.
3
a
b
SR 430, SR 450