Input Signal, Picture Mode And Display Status Information - Sony FWD-42PX2 Manual De Instrucciones

Input Signal, Picture Mode and
Display Status Information
Input signal and Picture Mode information appear on
the screen for about five seconds when the power is
turned on or when the input signal is switched.
To disable this function, follow the steps below.
1
Press MENU.
The main menu appears on the screen.
2
Press M/m to move the cursor (yellow) to
"CUSTOM SETUP" and press ENTER.
The CUSTOM SETUP menu appears on the
screen.
3
Press M/m to move the cursor (yellow) to
"Display" and press ENTER.
The following menu appears on the screen.
CUSTOM SETUP
Power Saving: Standard
Speaker Out: Off
Closed Caption: Off
Display: Off Off
Color Matrix: On Y/PB/PR
HD Mode: 1080i
RGB Mode: DTV
Sync Mode: H/Comp
Remote
Input Setting: Selectable
Select Set
ENTER
4
Press M/m to set "Display" to "Off," then press
ENTER.
Exit
MENU
To display the information
Set "Display" to "On" in step 2 above, then press
ENTER. The factory default setting is "On."
Note
You can display the input signal information and the
time anytime by pressing the DISPLAY button on the
Remote Commander, regardless of the above setting.
Watching the Picture
23
(GB)