Serial Numbers; Product Characteristics - Peg-Perego team FINA1702I257 Instrucciones De Uso

into place.
Always apply the chassis or stroller brake
before attaching and removing products
(refer to the respective instruction manuals).
Check that the child transport unit is
properly attached.

SERIAL NUMBERS

16 Information about the production date can
be found on the Chassis Team .
_ The product name, production date and serial
number of the chassis.
This information is required for any
complaints.
SEAT:

PRODUCT CHARACTERISTICS

_ The item is numbered progressively.
_ The Seat Pop-Up is a reversible seat: it can
turn to face mum or to face outwards.
INSTRUCTIONS
17 FRONT BAR: To attach the front bar, slide
the attachments into the armrests and push
towards the seat until they lock into place
(fig_a). To remove the front bar, press the two
buttons (fig_b) and pull out (fig_c). Open the
front bar on one side only, to facilitate the
child's entry and exit.
18 BACKREST: to adjust the backrest, lift the
handle (fig_a) and recline it to the desired
position (fig_b).The backrest can be adjusted
into different positions.
19 FOOTREST: before adjusting the foot rest,
ensure its cover is accurately fitted; if it isn't,
fit it accordingly. To lower the footrest push
the two levers downwards and then push
the footrest downwards (fig_a); to raise the
footrest lift it upwards (fig_b).
20 FIVE POINT SAFETY HARNESS: To fasten it,
push the two waist strap buckles (with the
shoulder straps attached – arrow_a) into
the leg divider until they click into place
(arrow_b). To unfasten it, press the round
button in the centre of the buckle (arrow_c)
and pull the waist straps out (arrow_d).
21 To tighten the waist strap, pull on both sides
in the direction of the arrow (arrow_a). To
loosen it, move it in the opposite direction.
22 To adjust the height of the safety harnesses,
release the two buckles on the rear of the
backrest.
Pull the shoulder straps towards you (arrow_a)
until the buckles are released and insert them
in the backrest loops (arrow_b). Remove the
shoulder straps from the sack (arrow_c) and
insert them in the most appropriate loop
(arrow_d), then re-attach the two buckles on
the rear of the backrest (arrow_e) The buckles
are securely attached when a click is heard
(fig_f).
23 HOOD: slide the hood's attachments into the
seat's attachments (fig_a), button the top part
of the hood on both sides of the seat (fig_b),
and finally fasten the sides with the elastics
(fig_c). The hood includes a slot from which
you can hang the child's favourite toy.
To remove the hood: pull out the attachments
and unbutton.
24 To extend the hood, unfasten the Velcro strap
on the rear (fig_a) and let the hood open
completely (fig_b). The hood comes with an
additional sun visor that can be pulled out at
the front (fig_c).
25 FASTENING THE SEAT TO THE CARRIAGE: Seat
Pop-Up can be secured to the carriage either
facing mom or the street. Place it centrally
on the carriage alongside the symbols (fig_a)
and press downwards with both hands
until it clicks into place (fig_b). To ensure it
is properly secured, grab the seat from the
front bar and pull upwards.
26 RELEASING THE SEAT FROM THE CARRIAGE:
Press the two buttons on the armrests of
the seat (fig_a) and then the two levers
underneath (fig_b); pull up the seat (fig_c)
until it releases. If the backrest is fully
reclined forward (in the closed position,
facing the world), the seat cannot be released
from the chassis (fig_d). In this case, lift
the backrest to the position of use before
releasing the seat from the chassis (fig_e).
27 CLOSING THE STROLLER: To close the stroller
with the seat facing the street, press the
backrest adjustment handle (fig_a) and lower
the backrest fully forward (fig_b). To open it,
lift the backrest to the position of use, until
it locks into place (fig_c). To close the stroller
with the seat facing mom, fully recline the
backrest (fig_d).
28 REMOVING THE COVER: unbutton the cover
along the armrests (fig_a) and the backrest
(fig_b), remove the cover from the footrest
(fig_c), unfasten the side elastics (fig_d),
unscrew (fig_e) and remove the harness on
both sides, and finally remove the crotch
strap from above, pushing from under the
seat (fig_f).
SERIAL NUMBERS
29 Seat Pop-Up reports information as at the
date of manufacture of the product.
_ Product name, date of manufacture and serial
number of the seat.
This information is required for any
complaints.
THE ORIGINAL ACCESSORY
PEG PEREGO
- 16 -