Docking Station Controls; Docking The Robotic Mower - Stihl RMI 632 PC-L Manual De Instrucciones

English
If the LED flashes slowly: The docking station is switched
on, the robotic mower has docked successfully or is being
charged.
If the LED glows for 3 seconds followed by a 1 second
pause: The "Homecall" function is activated and the robotic
mower has received a command to return to the docking
station.
If the LED flashes rapidly (approximately two times per
second): The perimeter wire is not properly connected to the
docking station or the wire signal is no longer present. The
perimeter wire may be broken (wire break).
If the LED flashes rapidly at intervals: The LED flashes
alternately 3 times at a 1- second interval, 3 times at a 2-
second interval, 3 times at a 1-second interval, 5 second
pause. After the pause, the signal is repeated. The docking
station has a malfunction. For troubleshooting information,
@ 22.

12.2 Docking Station Controls

ON/OFF/Home button
Press and hold the ON/OFF/Home button for
2 seconds during a mowing operation to switch off
the wire signal. The robotic mower will stop, remain in
the mowing area and a corresponding message will
appear in the display of the robotic mower.
46
1
Press the ON/OFF/Home button twice within
2 seconds during a mowing operation to bring back
the robotic mower to the docking station (Homecall).
The robotic mower will end its current mowing
operation, search for the perimeter wire and return to
the docking station to recharge the battery. When
Homecall is initiated, the robotic mower will not start
any further mowing operations during the current
active time. A Homecall remains active until the
robotic mower is docked. You can end Homecall
manually by pressing the ON/OFF/Home button twice
within 2 seconds. It will resume mowing operations
during its next scheduled active time.

12.3 Docking the Robotic Mower

Automatic docking
The robotic mower will travel to the docking station
automatically and dock when the active time ends or the
robotic mower needs to be recharged.
Docking with the Homecall function
The robotic mower can be called back to the docking station
manually. To call the robotic mower back:
► Press the ON/OFF/Home button on the docking station
twice within 2 seconds.
The robotic mower will return to the docking station and
will not start any further mowing operation during the
current active time.
Manual docking
► Remove the control panel / manual controller and activate
the Manual mowing command, @ 17.4 and @ 14.3.
► Steer the robotic mower to the docking station using the
control panel / manual controller or activate the disabling
device and transport the robotic mower to the docking
station by hand, @ 18.1.
12 Docking Station
0478-131-3052-A