Docking Station; Led On The Docking Station; Docking Station Controls - Stihl RMI 422 PC-LF Manual De Instrucciones

English
In the garden sketch, note those areas where the perimeter
wire is routed closer to the edge of the mowing area.
► Install the perimeter wire (1) with the aid of the
iMow Ruler (2) as illustrated.
– a = 9 in. (22 cm)

12 Docking Station

12.1 LED on the Docking Station

A red LED (1) shows the status of the docking station and
the perimeter wire signal.
If the LED is off: The docking station is switched off and the
wire signal is not being transmitted.
If the LED glows: The docking station is switched on and the
robotic mower is not docked.
44
1
If the LED flashes slowly: The docking station is switched
on, the robotic mower has docked successfully or is being
charged.
If the LED glows for 3 seconds followed by a 1 second
pause: The "Homecall" function is activated and the robotic
mower has received a command to return to the docking
station.
If the LED flashes rapidly (approximately two times per
second): The perimeter wire is not properly connected to the
docking station or the wire signal is no longer present. The
perimeter wire may be broken (wire break).
If the LED flashes rapidly at intervals: The LED flashes
alternately 3 times at a 1- second interval, 3 times at a 2-
second interval, 3 times at a 1-second interval, 5 second
pause. After the pause, the signal is repeated. The docking
station has a malfunction. For troubleshooting information,
@ 22.

12.2 Docking Station Controls

ON/OFF/Home button
Press and hold the ON/OFF/Home button for
2 seconds during a mowing operation to switch off
the wire signal. The robotic mower will stop, remain in
the mowing area and a corresponding message will
appear in the display of the robotic mower.
12 Docking Station
1
0478-131-3050-A