Installation - Stihl RMI 632 PC-L Manual De Instrucciones

English
Track offset
Change the robotic mower's standard 2.36 in. (6 cm)
offset from the perimeter wire to a smaller or larger
offset (1.18 in. to 3.54 in. (3 cm to 9 cm)).
To ensure optimal performance under the standard
setup instructions, STIHL recommends that you keep
the default track offset setting.
Language
Set the desired display language. The language
selected during initial installation is set as the default.
Contrast
Change the display's contrast.
Energy mode
If the mode is set to "Standard" (default setting), the
robotic mower is connected to the Internet at all times
and can be reached using the iMow App as long as
sufficient battery charge is available.
If the mode is set to "ECO", cellular communication is
deactivated when the robotic mower is in the docking
station to reduce energy consumption. The robotic
mower cannot be reached using the app, which will
continue to display the last data successfully
transmitted.

15.3 Installation

Passage (Offset Drive Home)
The robotic mower can travel back to the docking station
with an increased offset to the perimeter wire.
► Ensure that the perimeter wire has been routed with a
clearance of at least 2 m at the narrowest sections.
► Activate the passage setting to change the way the robotic
mower travels back home to the docking station. Select
one of three options:
58
– Off (default setting): The robotic mower travels along
the perimeter wire.
– Narrow: The robotic mower travels along the perimeter
wire or with an offset of 15.7 in. (40 cm) inside the
perimeter wire.
– Wide: The robotic mower travels within a passage of
15.7 in. to 31.5 in. (40 cm to 80 cm) from the perimeter
wire.
► If you have installed an external docking station, a
confined area or a linked section using a corridor, install
search loops for offset drive home, @ 11.9.
ASM (Anti-Stuck-Maneuver)
The robotic mower starts an evasive routine if it becomes
stuck: ASM is switched off by default.
► Leave the default setting (ASM switched off), if there are
large, flat expanses in the mowing area (e.g. asphalt
driveways), if the robotic mower often unexpectedly turns
90° during operation or if the mower unexpectedly stops
mowing and the display shows the message "1131 -
Stuck".
New installation
The current mowing plan will be deleted and the
installation assistant will start again.
Starting points
To set starting points, see @ 15.6.
Test edge
Start a test run for checking correct wire routing. The
step "Check installation" of the installation assistant
will be called up, @ 10.7.
► To check correct wire routing around restricted areas,
position the robotic mower in the mowing area with the
front facing the restricted area and start the test run.
15 Settings
0478-131-3052-A