Checking The Installation Position Of The Mowing Deck; Maintenance Interval; Changing The Wheels - Stihl RT 5097.1 Manual De Instrucciones

Installing the mowing blade:
Risk of injury!
Before installing, check the mowing
blade for damage (notches or
cracks) and wear.
Worn or damaged mowing blades
must be replaced.
Replace the retaining washer each
time the blade is installed.
Additionally secure the blade
fastening screw with Loctite 243.
Observe the specified torque of
65 - 70 Nm when tightening the
blade fastening screws, as the
secure attachment of the cutting
tool depends on this.
● Install the mowing blade with the curved
vanes pointing upwards (towards the
mowing deck).
52
Fit the mowing blade (1), screw in the
blade fastening screw (2 – apply Loctite
243) with retaining washer (3 – observe
convexity) and tighten to a torque of
65 - 70 Nm. Counterhold the mowing
blade when tightening the blade fastening
screw.
● RT 5112 Z, RT 6112 ZL, RT 6127 ZL:
Check the installation position of the
mowing blades.
15.14 Checking the installation
position of the mowing deck

Maintenance interval:

Every 50 operating hours or as required
(e.g. following severe impacts to the
mowing deck or a poor cut).
Uniform tyre pressure is a
prerequisite for checking the
correct installation position.
Therefore check the tyre pressure
of all the tyres and adjust if
necessary before checking the
installation position. (
The mowing deck is in the correct
installation position when it is tilted slightly
forwards – the front of the mowing deck is
slightly lower than the rear.
● Park the machine on level ground.
● Stop the engine. ( 13.3)
● Engage the parking brake. (
● Remove the ignition key and keep it in a
safe place.
● Select the lowest cutting level. (
Difference in height A = 10 mm.

15.15 Changing the wheels

In the case of damage (holes, cracks, cuts,
etc.) to the wheels, remove the damaged
wheel and take it to a specialised dealer.
Lifting and supporting the machine:
15.16)
Risk of injury!
Bear in mind the heavy weight of
the machine when lifting it (see
section "Technical specifications").
(
If necessary, lift the machine with
the help of a second person or
using a jack (not included in the
standard equipment).
8.14)
Secure the machine against rolling
away before lifting.
The brake only acts on the rear
wheels. Secure the machine
8.15)
against rolling away when lifting the
rear axle.
22.)
0478 192 9813 C - EN