WEG CFW700 Manual Del Usuario página 26

Open collector encoder
(b) Encoder with open collector
output
Refer to Figure A.3 on page 202
signals), the S1 DIP-switches (to select the type of signal of the analog inputs and outputs)
and S2 (RS-485 network termination) and slots 3 and 5 for accessories (see
ACCESSORIES on page
The CFW700 inverters are supplied with the digital inputs configured as active high and the
Figure 3.5: (a) to (c) XC1 connection terminals
Signal
A
A
B
B
Figure 3.6: Sequence of the encoder signals
to find the control board, the XC1 connector (control
58).
Installation and Connection
Active low digital inputs
(c) Active low digital inputs
Time
CFW700 | 21
section 7.2